Hello all,
So I finally got the head pulled today while doing my head gasket repair and I did a little searching on 'Mud and it seems that by upgrading the intake valves size might increase power a bit and improve gas mileage.
My question is, if I upgrade the valves, which manufacturer and what size should I go with? Supertech, Ferrea? I should say that I am want to keep the stock cams.
I was told by a 2jz engine builder that a ported intake and throttle body along with upgraded valves and ported head can help the 1fz a lot and could add about 25 to 40 horsepower. I have already ported the throttle body based on @NLXTACY review (thanks Joey). All I am looking for is a little more HP to help with getting on the hwy or going up hill with my drift boat. I don't really want to boost compression at this time in case I go turbo down the road.
Thoughts? Comments? Is this a terrible idea? All are appreciated! @inkpot ? @beno? @LINUS?? @scottryana ? I look to you guys for wisdom.
PS would you all install a catch can once its all button up? Also anybody else ported and polished the intake?
So I finally got the head pulled today while doing my head gasket repair and I did a little searching on 'Mud and it seems that by upgrading the intake valves size might increase power a bit and improve gas mileage.
My question is, if I upgrade the valves, which manufacturer and what size should I go with? Supertech, Ferrea? I should say that I am want to keep the stock cams.
I was told by a 2jz engine builder that a ported intake and throttle body along with upgraded valves and ported head can help the 1fz a lot and could add about 25 to 40 horsepower. I have already ported the throttle body based on @NLXTACY review (thanks Joey). All I am looking for is a little more HP to help with getting on the hwy or going up hill with my drift boat. I don't really want to boost compression at this time in case I go turbo down the road.
Thoughts? Comments? Is this a terrible idea? All are appreciated! @inkpot ? @beno? @LINUS?? @scottryana ? I look to you guys for wisdom.
PS would you all install a catch can once its all button up? Also anybody else ported and polished the intake?
Last edited: