Turns Over But Wont Start

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 15, 2005
Threads
157
Messages
980
Great way to start off the New Year.:rolleyes:

It's been a while since I've needed help, but today when I went to start the LX it turned over like normal, but did not fire up. It almost fired up the first time I turned the key, but now all that is turning is the starter. It acts like it's either not getting fuel or spark. Not sure which. I did a quick fuse check and all seem fine.

I'm hoping this is a simple problem.:)
 
check engine light show up when you turn the key one "click"???
 
It's not doing the clicking thing. The starter is good as are all the other little things listed in the Emergency Proceedures FAQ. I'm pretty sure Raventai's suggestion is what's up. I think it's getting spark, but not fuel. It will be a few days before I have time to pull that relay, clean it and go from there.

Thanks!

Chad
 
Did you check for fuel pressure? did you check for spark? you need to nail the problem down before you can fix it with any confidence.
 
Chad,

Hope you are doing well. I had the same thing after i got my head gasket done. I was close to being in tears after putting that much work into it and it wouldn't start. Same symptoms as yours too. The problem ended up being a (really) dirty air flow sensor. Just spray some cleaner in there and try it out. The fuel was fine in my my LX. Hope this helps.

Q
P.S. Just got done with my front end service
 
Chad,

Hope you are doing well. I had the same thing after i got my head gasket done. I was close to being in tears after putting that much work into it and it wouldn't start. Same symptoms as yours too. The problem ended up being a (really) dirty air flow sensor. Just spray some cleaner in there and try it out. The fuel was fine in my my LX. Hope this helps.

Q
P.S. Just got done with my front end service

Cool. I'll give it a good cleaning just to be sure. I'll also being servicing the front on this one soon.

Did you check for fuel pressure? did you check for spark? you need to nail the problem down before you can fix it with any confidence.
Got it. I plan on checking everything in a couple days. I'm out and about right now. Any suggestions on a good OBDII scanner? This is just the excuse I need to get one finally.
Check EFI relay if your getting no engine light put in another Efi relay for about 12 dollars. HAPPY NEW YEAR! Mike
I'll be checking the relay too. Thanks!
 
OBDII scanner, I have an Actron code puller and eraser, that I got years ago. it seams well made and works well, were I to buy one today I would look at the scangaugeII heard good things about it here, does a lot more on top of just pulling codes.

An OBDII scanner is a good thing in general to have but in this case without a running engine you are unlikely to have any codes.
 
Raventai I owe you a :beer: or two! I gave the relay a couple of whacks and used your/LT's match striker trick to clean the contacts and voila - ingition (They looked clean btw).

I'm going to look into that scanner you mentioned.

Thanks much bro!
 
Last edited:
Cool glad you got it going,

mine did not look bad either, but cleaning fixes it for quite a while, new relay is around $100, when they are going bad you may get the other symptom besides no start: severe stumble on heavy acceleration that instantly clears up as the gas is let off some.
 
Back
Top Bottom