This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #2
Ok im new to this forum
I have a 98 lx470 and the high beams do not work nor does the drl
When I go through the test I get a ohm reading of 82.9
Then a tone and 0
Then 83.3 ohms
Then I hook up 2 12volt leads to terminals a1 and b3 and get ol
Then I do the same for b3 and b4 and test again and get ol or open line ..... am I even doing this correctly?
I have a 98 lx470 and the high beams do not work nor does the drl
When I go through the test I get a ohm reading of 82.9
Then a tone and 0
Then 83.3 ohms
Then I hook up 2 12volt leads to terminals a1 and b3 and get ol
Then I do the same for b3 and b4 and test again and get ol or open line ..... am I even doing this correctly?