TRE Tapers

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 24, 2004
Threads
96
Messages
1,599
Location
Monroe, WA
Does anyone know if the TRE size/taper is the same for early FJ40s, late FJ40s, and minitrucks? I know FJ80s are bigger, but I never hear anything mentioned about earlier rigs.

Thanks,
Eric
 
e rock said:
Does anyone know if the TRE size/taper is the same for early FJ40s, late FJ40s, and minitrucks? I know FJ80s are bigger, but I never hear anything mentioned about earlier rigs.

Thanks,
Eric
The minitrucks have the larger taper. FJ6Xs are larger than the 40s too. I'm pretty sure that all 40s have the smaller taper, but I don't know for sure.
 
Last edited:
You can calculate the taper.
SAE tapers are sold as diameter change per foot (ie 5/8"/foot). Measure the larger side, measure the smaller side and subtract that from the larger side. Measure the lemgth of the TRE taper, divide the first nymber by this number and express the result as inches/foot.

Metric tapers are easier because they are sold by ratio, ie 1:50. Measure the larger side, measure the smaller side and subtract that from the larger side. Measure the lemgth of the TRE taper, divide the first nymber. This is the taper ratio.
 
Back
Top Bottom