Transmission/Transfer ??????????

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 15, 2006
Threads
93
Messages
577
Location
Redding, CA
Was going to do mini-truck ps conversion on my 71 FJ40 and ran into a snag when I found that I can't do it and keep my column shift 3-speed. So since I'm going to have to go to floor shift I figure I might as well convert to 4-speed. Saw someplace that there is a 4-speed that will bolt right up to my 3-speed transfer. Mine also has the transfer shift (I think it is vacuum) below the dash. Should I think about changing this while I'm at it? My FJ is used as semi-DD and weekend mild 4-wheeling. Finally does anybody have what I need to do this and how much? Would like to locate a transmission hump so that I could save mine in case want to return it to stock. Worse part about all this is I just did a complete clutch job.
 
Good idea, going to a four speed, you can get the "crossover " gear in the Toyota trails mag ...I think its a 73/74 input gear ...other than that your transfer will bolt up. Why not go with saginaw power steering,one of the main reasons I did was to get rid of all the eccess slop in linkages, also spector off road can get you a "hump" used.. good luck!
 
I don't think any tranny swap is a simple bolt-up deal. The Toyota tranny needs a belhouseing change, The Chevys requier an adapter to the T-case, and all mean driveline work. If I were doing mine today I would look at t a 5 speed. All the swaps are in the tech section of this site. Good Luck how ever you go.
 
Main reason I was going mini ps conversion is that I don't weld. Have also heard that with the full Sag ps you lose feeling. Somebody referred to it as hands on novocaine.
 
tow your truck to a fab shop and ask them to weld it.... maybe $60 at best you would still do everything just no the welding of the box mount and steering shaft
 
mikealeus said:
Main reason I was going mini ps conversion is that I don't weld. Have also heard that with the full Sag ps you lose feeling. Somebody referred to it as hands on novocaine.

I have been told the problem with a minitruck ps conversion is the pump will overheat on the trails with larger tires. The saginaw is a much more heavy duty setup. I have had two FJ40s with saginaw ps conversion and I dont think you "lose feeling" when driving. This setup is even better when done with a high-steer kit to help eliimiate bump steer.
 
ok the 4speed trany is 3 1/2" longer then the 3 speed trany. So to use the same dash mount shifter you need to lenthen the rod that runs between the motor mount and the t-case hi/low shift fork. you will see when you put a 3 speed next to a 4 speed. Its really cool the keep the dash shift cuz you can put it in N and no one knows
 
Back
Top Bottom