transmission rear mount

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 18, 2003
Threads
56
Messages
107
Location
South Hadley mass
I have a chevy 350 to stock toyota tranny and transfercase77fj40. Does anyone have any pics of a mount that goes under the tranny. I have the one that mounts at the end of the transfercase but there's nothing in between the motor mounts and the mounts on the transfercase. did some good wheeling this week and noticed it was moving enough to get me to worry. No problems since finished up a year ago but much happier if there was something there.I will post pics when my wife get's time to down load them.

77 fj40 350,4spd toyota,35'bfgm/t,9,000milemarker,yota power steering,6 point cage,tuffy cosole,4'skyjacker.
 
i think that you will find most of the V-8 swaps are done that way. my 76 has the same mounts you are talking about (advance adapters) and its been 4 years with no problems, yes it does move a little, but i never worried much about it, you might check and make sure all the nuts and bolts are tightened down other then that you should be fine. you could fab something but i dont see a real need. good luck!!
 
Hi All:

If you are really worried, there is an option you could consider. The H42 four speed trannys from FJ60s have a built-in transmission mount on the underneath of the transmission case itself. You find a junker FJ40 tranny and swap all the interals from your current tranny (since a FJ60 tranny won't work with your t-case) into the transmisson case.

Regards,

Alan
Seattle
 
Back
Top Bottom