Transmission flush question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 9, 2008
Threads
22
Messages
58
Location
Calgary, AB
Planning a transmission flush on my '90 HDJ81. Got everything ready and read almost all threads talking about the topic including this one with pics:
https://forum.ih8mud.com/80-series-tech/19299-transmission-fluid-exchange-writeup.html

I am still having some trouble finding the transmission line to disconnect. I understand from the picture it is on the LH side of the vehicle. Is that right? Roughly, how far down the radiator it is located? The picture in the thread mentioned above seem to have an additional transmission cooler (this is where the hose is connected I guess) while mine is stock and does not have one (uses part of the radiator as a transmission cooler)
Also, I read that the right hose size should be 3/4" ID, does this sound right? 3/4" is really BIG!!

I am also planning on using this before flushing, any comments or previous experience with this product?
http://www.amazon.com/TRANS-TUNE-16-OZ/dp/B0002JN2F4?tag=ihco-20

Cheers,
Ahmed
 
Last edited:
I would expect the line to be around 5/8" OD. If you're not sure which line is the transmission input line, just disconnect both and point them both into a bucket. Only one will expel fluid when you turn the car on then reconnect the other for neatness. I've never used any additional cleaning products in my transmission and most people on this board seem hesitant to do so. Have fun.
 
This may be obvious,

but you could leave the plug on the pan partially open, start the car, and keep filling it with tranny fluid until it is running clean and clear.

I recommend staying away from force flushing or any additives.
 
The output line should be the one towards the front of your vehicle. The one to the rear is the input after going through the cooling system...
 
Back
Top Bottom