So the next move was to make something to protect the transfer case, especially after laying it out on the trail. It was not fun to replace the rear output seals.
I am not that good with bending metal but I can work around a welder so here it is;
From sections I was able to angle the plates to mold around the Transfer case and towards the front driveline. I built in side supports as seen in the pics to prevent it from moving, the nuts were already in the frame so I worked with that.
All in all I think it worked out pretty good, the only thing I probably will do is drill out some quarter size holes to allow for breathing and drainage.

I am not that good with bending metal but I can work around a welder so here it is;
From sections I was able to angle the plates to mold around the Transfer case and towards the front driveline. I built in side supports as seen in the pics to prevent it from moving, the nuts were already in the frame so I worked with that.
All in all I think it worked out pretty good, the only thing I probably will do is drill out some quarter size holes to allow for breathing and drainage.
