Tranny swap?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 30, 2005
Threads
13
Messages
95
Location
Blenheim, New Zealand
I have a late model 4 speed tranny with the engine mounts on the tranny, and the park brake on the rear wheel drums, but it is popping out of first. I have tracked down a good tranny for a good price, but it is off an older Cruiser with the rear engine mount on the bellhousing, and the park brake on the transfer box output shaft. Is it worth getting so I can pull them both apart & rebuild my tranny with the good parts, or are they not compatible for mix and match? Thanks
 
Sounds like you have the newer split case TC. I wouldn’t think these are compatible with the older type TCs. I would hold out for the correct TC or repair the one you have.

Good Luck!
 
From the FAQ in Tech Links:

It looks like if you're swapping parts between H42 trannies you shouldn't have a problem unless you need the output shaft. Spline count goes from 16 to 19 in 1981. But the gears are the same, which means the tower and shift forks are likely the same too.

If your current tranny is an H41 you'll have issues trying to use parts from an H42 - gear ratios are different so at least the shift forks are different. Could have the same tower and detents though. Can't say about synchros or bearings.

Someone with "real" knowledge will confirm hopefully. HTH
 
If it's the same trans, either the H42 or the H41, as yours, and it isn't from a diesel powered truck while yours is running on a gas you should be OK. The input shafts differ in transmissions for each fuel type engine.

(If it is an H41 while yours an H42, both same fueled, you could take advantage of the considerably lower first gear of the H41)

If the new to you trans is working and is the type you have you might consider simply swapping them rather than trading parts from one to the other. Yhey're supposed to be tough to overhaul.
 
Back
Top Bottom