Tranny hump Modification

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 28, 2005
Threads
14
Messages
33
Location
Fairfield, CA
OK, I've installed a 4spd tranny and transfer case in my 65 cruiser. Now I need to modify the Hump for the new floor shifter. Does anyone have pictures or advice about this undertaking. I read on some post where a later model hump cover could be adapted, but couldn't find it again. Oh I don't think it matters but I have a Chevy SB 350 in the rig but the shifter is in the stock location.
Thanks Dave
 
I used a tranny hump from a 76 when I installed a 4 speed into my 68. I just trimed the back of the cover to match the earlier one. Flatened the hump on the passinger side to match the floor. used sheet metal screws to keep it tight at that location. The reat of the bolt holes lined up. I also used a thick rubber gasket across the back because the newer hump is a little taller in the back. I did this in the early nineties, but I sure this is how I did it.


John
 
Whatever you do, do not get SOR's 73 - 78 fiberglass one and think it will fit no problem, i tried it and am now looking for an early model one.Too much modification in fiberglass for me. Then again this truck never came with one to begin with.
 
Do you need to just make a hole for the shifter or is the tranny sticking up and in the way? I cut mine with a angle grinder to let it fit over the tranny and than made cardboard mockups of the patches I needed. A local sheetmatal shop charged about $25.00 to bend up a square pan to raise the top and one for the side. I used a mig to weld them to the tranny cover .
 
From what I understand the 4 speed sits higher and a littler closer to the passenger side then the original 3 speed tranny cover. I plan on trying to modify what I have first and if that dosen't work try out some other fixes. If anyone has done this modification already and has some pictures would be helpful.
 
Last edited:
Sorry, I have nothing to add, but i will be doing this soon and just wanted to subscribe to the thread. Good info, so far.

Ed
 
Dave, when I converted my column shift to floor shift, I took off the shifter cane and put a nice coat of grease on the the shifter top (the round part where the cane goes) and carefully laid the cover back on and let it touch the grease.
Removed it and used a 3" hole saw for a perfect fit. The TC shifter was a little different story, and not as precise, but it still covered with the stock boot.
FJ60 shifter boots are larger and a little more forgiving if you get the hole a little too big.
Worked for me.
Good Luck

Ed
 
Just thought I drop a quick note as to what I did. I was able to, modify, (cut bend and cuss), my 65 hump to fit over the 4 speed and transfer. I cut one long rectangular hole from the Tranny shifter to the transfer shifter. Now I am in the process of making a custom steel insert to fill the hole with stock openings for both boots. Once fitted I will weld them into place grind smooth and paint. So far looks good. Thanks for the input.
 
Back
Top Bottom