Tranny doesn’t lockup, sometimes.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Nice find Rick. I am thinking this problem is along the same lines. I am able to confuse the Transmision ECU by giving it input it was not meant to handle...Like perhaps on the gas a fraction of a second before I drop it into D. It responds with no tranny lockup. thanks for the link.

Maybe the 80 series tranny has a "self preservation" mode :D

Back in my High School days kids with ATs used to do what we called neutral drops...Put the vehicle in neutral, rev the engine way up, and drop the tranny into Drive. The intent was to do burnouts of course :cool:

I've never tried doing a neutral drop in my LX or 80 but it sounds like you kind of occassionally do something similar but not near as harsh by stepping on the skinny pedal a little early when shifting into drive.

Anyone ever tested what an 80 series will do if you do a neutral drop?? Maybe while you were trying to "rock" the rig when stuck in snow?

I know when I shift into Reverse or Drive there seems to be a short (maybe 1/2 second) lag before the tranny lockups but it is not anything like what you describe...
 
Last edited:
Back in my High School days kids with ATs used to do what we called neutral drops...Put the vehicle in neutral, rev the engine way up, and drop the tranny into Drive. The intent was to do burnouts of course :cool:

Agh, the 70's and 80's, and the fun of trying to do a burnout with a 4cyl or v-6 car putting out 100 horsepower. Then there were those lovely late 70's V-8's, thinks like the Chevy 305, which GM would then kindly backup up with a 2.73 rear diff so it would get decent mileage. Nothing like 140hp, 180pounds of torque, and a rear end that was so tall, 1st gear was good for 70mph. I still remember trying to do a power stand in V-6 Thunderbird and not being able to get the rear wheels to spin. Traction control, we don't need no stinkin traction control.
 
The D problem was fixed by replacing the lights in the dash.


So…back to our original subject. I tried a couple of mild “neutral drops” and it obediently dropped into gear. I even tried to step on the gas at the same time I dropped it into gear but I cannot replicated the no-lock behavior. Since I can’t replicate it I am not going to worry about it but it may actually be a shift solenoid going bad.
 
I've had a similar situation in which after braking very hard, the 80 hesitates to take off right away. It takes a few seconds for it to go. I've noticed some hesitation after braking, and alot after hard braking....if I slam my brakes hard, it won't take off right away.
 
Back
Top Bottom