- Thread starter
- #21
Here is the finished front axle, I did not know for sure but I am happy to report that FJ40 and Mini Aisan lockouts are a direct replacement for the fulltime factory stuff!
ARCHIVE Toyota Rear Full Floating Axle Flanges!
- Thread starter Dan Fredrickson
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Thread starter
- #22
And yes, those are the Hellfire Fab Knuckles and High Steer!
Dan,
The minitruck and 60 series aisins work on the early model birfs. The 12/93? and later prductions are the longer outer and they wont work, nor will bobbys longs. Not trying to be a know it all but thought you should know this.
The minitruck and 60 series aisins work on the early model birfs. The 12/93? and later prductions are the longer outer and they wont work, nor will bobbys longs. Not trying to be a know it all but thought you should know this.
- Thread starter
- #24
Thats good to know, these were from a '92 or '93 LX450...
- Thread starter
- #25
Now available in 3.5", 3.25", & 3" ID so you can add them to just about any axle tube size...
- Thread starter
- #26
Didn't get anything done this weekend on my project but I did get some new parts at Georg's swapmeet!
- Thread starter
- #27
Wanting to build a custom rear end? These give you full-float strength, and the spindles, hubs, breaks, etc on all 4 corners!
Designed initially to go on our axle housings, but available with smaller IDs to work with many others!
Designed initially to go on our axle housings, but available with smaller IDs to work with many others!
- Thread starter
- #28
We have them for 3", 3.25" and 3.5" OD axle tubes.
- Thread starter
- #29
it's nice to be able to have the same Hubs, Spindles, Bearings, and brakes on all 4 corners!
- Thread starter
- #30
Build it the way you like it...