So I have a few questions about the front end. I have a 94 toyota 4 Runner. I have the ifs front end and need to replace the A arm bushing and bearing. Also the rubber boots that go over the drive shaft. How should I go about changing them? more or less would it be better to have them done or is is possible I can do it myself
Toyo 4runner front A arm bushing replacement
- Thread starter annoved232
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
SuperPro (polyurethane Bushings) AU has two bushings set for 4runner control arm.
Set 1
SPF2028K - Control Arm Lower-Inner Bushing ("Re-use original" OE# 48061-35011) - $142.80
SPF1303K - Control Arm Upper-Inner Kit ("Re-use original shell") - $91.25
Set 2
SPF2337K - Control Arm Lower-Inner Bushing (Replacement shell & bush Kit OE# 48061-35011) - $202.03
SPF2338K - Control Arm Upper-Inner Kit (Replacement shell & bush kit) - $185.85
Information about SuperPro can be found here: http://superpro.com.au/why-superpro
Best regards.
Set 1
SPF2028K - Control Arm Lower-Inner Bushing ("Re-use original" OE# 48061-35011) - $142.80
SPF1303K - Control Arm Upper-Inner Kit ("Re-use original shell") - $91.25
Set 2
SPF2337K - Control Arm Lower-Inner Bushing (Replacement shell & bush Kit OE# 48061-35011) - $202.03
SPF2338K - Control Arm Upper-Inner Kit (Replacement shell & bush kit) - $185.85
Information about SuperPro can be found here: http://superpro.com.au/why-superpro
Best regards.