TOW rig tech

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 19, 2004
Threads
107
Messages
375
Location
Lewisville, NC
NOT cruiser related but you guys always help out so quickly on most issues.

My DD is a '96 chevy suburban. I just tried to get the inspection here in NC and my MIL(?!?) light is not coming on when I turn the iginition to the on position. does anyone know of the procedure for resetting the light? or is it going to come down to me disassembling the dash to get to the stupid check engine dash light to check out the bulb?

THanks
spence
 
What is the "MIL" light?
I'm guessing some sort of Instrument light?
Did ya pull the codes? Is there anything wrong with the vehicle?
What engine? Tranny? I'm guessing vortec v8 either the bigger one or the smaller one and a 4l60E or 4l80E but can't help without more info..
 
ttt

the MIL light is the "service engine soon" light.

it is the v8 vortec not sure of transmission.

is the only way to reset the light is unhook the battery?

Thanks
Spence
 
Usually you reset the light if it stays on, not when it won't come on. I'd go Denis's way and look for a bulb out or maybe that someone deactivated the thing because it's an irritant.
 
Honk is correct, the battery reset works when the MIL is on. Check the firewall connector (C100) -- this mates the main engine harness and computer to the instrument panel through the firewall. Pin B6 is the MIL connection. With the ignition ON and the engine off, you should see 12 volts on B6. If you have power to B6 under those conditions, then the indicator light bvulb is either burned out or there is a disconnection between the C100 connector and the bulb.
 
Easy in my Land Cruisers.....more than likely not so easy in a Suburban. I have no experience with the OEM, but you probably have to do major disassembly of the dash.
 
7mm socket and about 10min to change that bulb. Unplug the odo while you have it apart! The dash just pops off without any tools then take the four 7mm screws out of the guage cluster. Next take the cluster to your woork bench and dissasemble. It is really simple.
 
Back
Top Bottom