total heater bypass

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 19, 2013
Threads
38
Messages
562
Location
Eastvale, CA 92880
I am planning to bypass the entire heater system. I tried looking around if anyone has done this but have not found anything so far. Maybe someone knows a link that can help me out. So my plan is to cap the heater outlet where the PHH originates and cap the heater inlet above the thermostat housing. Is this a sound idea? Any reason why i should not do this? Thanks in advance.
 
Fairly simple was just eyeballing this yesterday. Where PHH connects to heater valve, remove the valve and hose, then go to water pipe on side of engine. This is where it goes after circulating through heat exchanger in the cab and coming back out the firewall. I removed the rear heater as there were to many points of failure for my liking.

I carry about 5 feet of HH with me and 2 extra clamps. If the PHH goes or any part of the heater plumbing, running straight from PHH on the side of the block, to the tube that goes into thermostat housing, will get you home perfectly fine, just no heater
 
Thinking about this route as well. So long phh to connect directly to the metal heater pipe on the passenger side instead of sealing off the outlet and inlet right?
 
you can buy rubber covers for the heater barbs that come off the firewall to prevent creatures, might aslo make sense to leave open so fluid will evaporate, dont know
 
Back
Top Bottom