Torque Spec for Oil Set Retainer

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 28, 2004
Threads
72
Messages
1,101
Location
San Diego
Doing my front axle servicing for the first time. I need the torque spec for the 6 bolts on the back of the knuckle. The six bolts that hold the oil seal set retainer to the knuckle.

Talking to Dan, he mentioned that these bolts will break when over-torqued. Well, I don't want to under-torque them either. For the life of me, I can't find these numbers.
 
Whatever it is, it's in inch-pounds. There's no rotational force on them, so you don't have to be too concerned with them backing off. The seals provide a constant pressure, which helps keep them in place too. I tighten them until I'm afraid I'm bending the metal ring too much- which is easy to do. You could probably tighten them fine with a nut driver, I use a quarter-drive socket and go easy.

-Spike
 
Back
Top Bottom