Too much rust?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Tried to mark it. Pretty minor but something. To look at. It wouldn’t stop me but just something to address. I just got a 2001 100 that looks way worst. It was 2k. Though. All about price point.

08191960-8B8D-45DE-B151-2EC8CEE5DAEB.webp
 
A little taste of what you're in for: Check it out

IMO it's only worth adding POR-15 or similar if you can fully remove the part and sandblast, degrease and spray multiple coats of POR-15. He ended up hiring someone to spray the rear without fully removing parts and it's starting to rust through.

You could also just generously spray with WoolWax and drive it!


POR15 doesn’t adhere near as well to clean blasted steel as it does to rusty. In fact I often let things flash rust if I had them blasted and will be putting POR15 on it.

It is also a somewhat pita to apply correctly and if you don’t it most certainly will not last. It also likes to go on and cure out with high humidity.

I have worked with it a lot.


Me personally, I don’t touch trucks with that much rust. I see tons of busted bolts there if you put a wrench on them. On top of that, even the most rust free frame will have some rust between the steel. Such as where a bracket is welded to the frame. So you can be sure a truck that has a chassis as rusty as this one pictured, is slowly rotting from the inside out. It has very obviously seen salted roads, that’s not just rust from age, rust from age doesn’t look like that.

Cheers
 
Last edited:
The old lube the rust technique. Fluid film, wool wax, bar n chain oil, motor oil or whatever is clever. Takes along time but it does get better.

The sway bar just remove, wire wheel to death and paint. The sway bar mounts can be done then too.
The trans cross member bolts spray with PB Blaster or Kroil whenever you think of it. Only after doing that attempt to remove them.
The actual cross member just replace with a nicer one you already fixed up and painted.
The rear axle just keep working on with needle gun and or a wire wheel and paint. Same thing on the frame, a little at a time.
Just chip away at it all slowly and it'll all be fine.
Rusted bolt removal is easier after PB Blaster or Kroil has been applied many, many times over a long period. Not hours but weeks or longer.

The body mount thing I would tackle sooner than later. Wire wheel/needle gun, rust disolver, rust converter, cleaning and painting.
Your rust stuff isn't that big of a deal yet.
Just keep after it.
The Fluid Film/Wool was should be applied to the entire clean dry underbody before the salt hits the roads yearly.
Redmearls work is incredibly!
 
Back
Top Bottom