Thrust Washer

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 19, 2005
Threads
20
Messages
228
Location
Plano
Say someone didn't install the thrust washer on the front axle outside the outer front wheel bearing. What issues or problems would this likely cause?

The PO didn't bother to install it on mine when they did or had the front end serviced last time. I found this when i tore it down today and to my surprise i'm missing one thrust washer.

Thanks,
Ben
 
The nut will not support the bearing as well as the washer, but if properly preloaded, it probably isn't a big deal. Just get a replacement washer and reassemble.
 
Yeah, thats the plan. The bearing was very loose and i could turn the nut with my hand when i took it off. I just wanted to make sure that there wasn't some other items to look at while its all down. Spindle, etc. Thanks.
 
I had that problem (of my own making) when I did my service last fall. I found the thrust washers a couple hundred miles later and popped them in. I didn't notice any difference on the road, but it sure was frustrating trying to set preload without the washers in there!

It's been about 2000 miles since and I haven't had any problems.
 
Well, I got everything back together and all seems well. Many thanks to all those who supply info to this forum, C-Dan for the parts, Romer for the Repack Write up and elmariachi for the DVD. The toughest part of the whole job was getting that darn circlip back on the axle at the end.
 
Back
Top Bottom