I teach an AutoCAD lab at the University of Arkansas, and being that the class consists of freshman and is at 7 a.m., I rarely have anyone to instruct. So I normally do my homework in there, but this morning I had no homework and decided I was going to bob the bed on my truck.
That meant i needed a new rear bumper, and what better thing to do while you are being paid, then to draw up a bumper for your truck?
That being said, here is what I had accomplished inbetween the few questions I had to go over. Thank god some upper level students couldnt afford to flunk class twice
That meant i needed a new rear bumper, and what better thing to do while you are being paid, then to draw up a bumper for your truck?
That being said, here is what I had accomplished inbetween the few questions I had to go over. Thank god some upper level students couldnt afford to flunk class twice
Actually figuring out bending is pretty easy. Figuring out how to afford a decent bender is kind of hard though. Worth every penny in the end.