Throtte Body Play

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 14, 2017
Threads
19
Messages
425
Location
Wakulla FLA
Please just play along with me here...

I looked thought the FSM and on throttle body threads, and havent seen a definitive answer on this. When you have the throttle body off for cleaning, and you engage the butterfly from open to close, when the butterfly snaps back, should it freely return to its complete closing point? After cleaning mine seems to fall about an 1/8" short of that mark, if measured on the bottom of the chamber. I THOUGHT the butterfly would close completely then allowing the IACV take over at idle. I also noticed that the bellows stopper behind the throttle plate seems to be positioned where it would make minimal/flush contact at the butterflies complete closing point, so when my butterfly shuts the plate is removed fromt the plunger. I plan on removing the TPS this evening and expecting it to be gummed up since my throttle body was so dirty, further making me feel it should close completely and maybe a gummed up TPS is causing the butterfly shortfall. Any thoughts before I dig into it further tonight? THANKS!!!!!! Really, like thanks a whole bunch.
 
IIRC the butterly doesn't completely close, but it's been 5yrs since I cleaned mine and just remembering what I read here.

Thanks for some input! Its an interesting conversation. Accross many makes and model discussions on this subject in general there appears to be competing ideas on how tight the butterfly closes. I tried to look at it in more of a general sense but broke down and threw it on here. Appreciate it.
 
Neither does mine!
 
Back
Top Bottom