Testing the harness

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 27, 2007
Threads
84
Messages
375
Location
Southport, NC
I think I've got a bad injector. I'm getting P0301 and have good spark to that cyl. I've checked the harness under the EGR and although it was missing the protective wrapping, the wires looked fine - I wrapped it with aluminum tape. What I want to do is test the harness at each injector to verify voltage and resistance. Does anyone have any specs, link, or testing procedures they can share?
 
Carefully remove the connector on injector #1 and measure the resistance of the the injector (across the 2 pins), should be in the 13 ohm range.

Helps if you also tell us (or add to your signature) the year etc of your 80 since I don't think a '71 40 series had obd2 :)


cheers,
george.
 
Thanks to you both, I'll do both of those. It's a 97 - I'll update my signature!
 
I also want to test the harness side of that injector plug to make sure I've got proper voltage and no shorts along the way.
 
I also want to test the harness side of that injector plug to make sure I've got proper voltage and no shorts along the way.

The easiest way is to listen to it, if it's clicking how it should, it's working, if not, then start the other tests.
 
You can used a noid light as an option to check the voltage pulsation pattern. If its isolated to the one injector I would see if there is a deviation in voltage from the rest of the injector plugs.
 
One of the pins is constant 12v, the other is the switched ground.
The ground goes to the ECU. I dont have an EWD with me or I'd tell you which pins go to which injectors.
I got the stethoscope recommend by Tools. It's pretty nifty. Then I tested the wires.
 
Checked the voltage and resistance on #1 and #2, both checked fine. 14.4 ohms across the pins on the injectors and 12v coming in from the harness.

That doesn't mean the injector hasn't failed though - right? There could still be a problem with the nozzle itself.
 
Back
Top Bottom