i just got done with the swap and the motor dosent start if i just turn the key over i have to put alil gas in the throttle body then it will run i turn the key and i get 11 pounds of feul pressure then it starts to slowly drop i used the painless wiring harness all i did was connected pink stripe to ingnition and brown to fuel pump i think thats right but why wont it run ? when i turn the key
tbi starting problems
- Thread starter donnie12
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
- Joined
- Sep 16, 2008
- Threads
- 96
- Messages
- 2,930
- Location
- Freensville
- Website
- www.poolpartydeathmachine.com
is the distributor set right?
Could you possibly break down each individual point in your initial post? It's all kinda running into itself, and makes for a confusing read.
Could you possibly break down each individual point in your initial post? It's all kinda running into itself, and makes for a confusing read.
Did you connect your starter signal wire? If you didn't, then how does the ECM know you are cranking, and to start firing the injectors?