TBI Intake

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Is the question how much would it cost or how much would it improve?

Putting a TBI on a carbed motor requires an adapter plate or machining the TBI intake to fit. The TBI heads had the center four bolts go straight in where earlier heads have an angled bolt.

the rest of the conversion is pretty cheap. The cost of the TBI, sensors and wiring harness. eBay, junk yard or the best way, buy a junker complete. You will also need a fuel pump. That can be pretty expensive. A bung will be needed to be welded in your exhaust near a head for the O2 sensor.


How much an improvement depends on where you live and how you wheel. In cold climates I love a TBI. No choke. Easy cold starts. For wheeling it will run at any angle and after any bump. No flooding or starving. It's much harder to stall as it will self correct the idle speed.

mileage and performance are marginally imporoved.
 
You can get the body off ebay between $50 & $100. Actually I ordered an extra one recently. To my knowledge the same units will work on 305 and 350. The plate I believe you can get from Howell Inc as well as a wiring harness. (Harness is $325.) Junk yard harness I'm not sure but again, watch ebay. I've seen intake, TBI, wiring harness, ECU and distributor listed, all for a little over $100. That's another thing, you'll need an ECU which you can find on ebay for $49, and I believe you'll need a TBI distributor.

Actually they sell a whole conversion kit for around $1000 or so. (Worse case.) And as mentioned you'll need a fuel pump which figure on around $100. (Little more or less depending on what you get.)

Thanks.
 
I was looking at prices. You said I could find one of these already put together at a junk yard? What kind of vehicle could I find this in? Or, where could I get a junker complete? I'll look on eBay. I thought this was an aftermarket upgrade.
 
Back
Top Bottom