taurus fan on sbc

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 22, 2005
Threads
74
Messages
1,061
Location
slc area
hey guys,

I'm looking to do the taurus fan conversion on my cruiser with a 350. Looked at lots of posts regarding this but what is EVERYTHING i will need to do this. I am keeping the stock radiator as it's fine, just heat up when i'm crawling on those hot utah summer days. All help greatly appreciated.
 
i'm actually in eagle mountain right by saratoga springs, which in turn is right by lehi. ever seen a step by step on this fan conv?? electrical is by far the least of my abilities :confused: thanks for the link
 
If I recall correctly, with the stock radiator setup and removal of the mechanical fan, the taurus fan fits almost perfectly over the stock radiator. I have been helping a friend recently and he decided to upgrade to a 19x22 griffin which makes things more difficult since the cradle has to be mofidifed. I think you can fab up some way to mount the taurus fan to the stock cradle pretty easily. Regarding the electrical (I haven't gotten that far yet on my buddy's setup), there are 3 wires for the Taurus fan: ground, skinny (low speed power), and the fat one (high speed power). You can run a manual switch to the dash and then turn it on and off as is necessary. The link above in pirate has great wiring diagrams. Later you can make the fan turn on automagically by using the thermostat in your setup. Good luck!
 
great links guys. definitely appreciate the help. i think i have a decent idea on the switch over now, at least i hope. i'll just keep it simple: off, low, high. i hope that will keep me crawling, hate to have to stop for summer :)
 
I'm running a taurus fan on a CCOT replacement stock radiator and just using a manual switch. If you look at the pirate4x4 link posted above, go to the bottom of the thread and you can see how I wired mine. Very easy to do. Just make sure you use quality relays.
As for mounting the fan, if fits perfect width wise. It is a little short so I just mounted mine at the top of the rad and left the bottom open...no big deal. It cools 10x better than my last electric fan. I can drive around town and crawl most of the time with it on low and then use high for the highway.
 
I put one on my stock FJ40 radiator. It really is a close fit. Becarefull of not cutting the plastic shroud down too much. There are a couple bolt tabs on the shroud that are easy to match holes or drill and attach to the radiator frame. The passenger side will need some brackets made. I used some flat stock aluminum front and back and pop riveted them together to fit existing holes in the frame. Be sure that the little clip that holds the fan on has atleast a half inch of clearance from the radiator. (1/4" inch is not enough! ouch!) There are three wires gound, low and high. I just used the high, and like Warpdriv I have a manual switch that I usually leave on all the time. (cuz I do smoke crack and I forget to turn the damn thing on until I smell anti-freeze.)

I bought my fan from the junk yard for $35. Most of the engines where pulled and the fans were tossed in the trunk or back seat. Walk the yard and I am sure you will find one already pulled in 10 min. The aluminum I got from Home Depot for $10.
 
interesting link skulls, sounds worth looking into. anybody had to upgrade their alternator when running this fan???
 
i bought this fan from the local salvage yard to install on my 71 fj40. but i have the engine too close to the radiator so it won't fit in there. the fan is 5 inches thick. it has the original in line relay. does anyone here want to buy it from me? otherwise i was going to list it on ebay.
 
Back
Top Bottom