Tacho not working after engine swap

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 3, 2020
Threads
1
Messages
2
Location
Australia
Having abit of a tacho issue if anyone has any input,
I blew up my 93 1hz and replaced it with a 92 model 1hdt and now have no tacho or speedo, was working fine in the donor car, didn’t touch the pump at all, used the loom from the HD and didn’t touch anything behind the dash
 
Welcome to mud!

Why would you assume that the loom from HDJ80 will just plug in and work? It will not..

92 HDJ Tach singnal goes through IG4 connector, Pin #11
93 HZJ signal goes through pin #23 of the same connector, assuming your truck had manual transmission. If automatic, it would go through the ECT ECU instead of IG4.

More info here:


92 HDJ couldve had mechanically driven speedometer, so the loom would not have the wire for the electronic speedo sensor at all..
 
Last edited:
Welcome to mud!

Why would you assume that the loom from HDJ80 will just plug in and work? It will not..

92 HDJ Tach singnal goes through IG4 connector, Pin #11
93 HZJ signal goes through pin #23 of the same connector, assuming your truck had manual transmission. If automatic, it would go through the ECT ECU instead of IG4.

More info here:


92 HDJ couldve had mechanically driven speedometer, so the loom would not have the wire for the electronic speedo sensor at all..

thanks for the reply, was told the loom would be the same and as it all just plugged in I figured it was, I’ll swap them back over and see how that goes
 
Back
Top Bottom