Tach stopped working

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 27, 2003
Threads
490
Messages
9,929
Location
North Cadillac
Just like the title says.

I did a total engine wiring harness swap last week and after finishing and driving the truck, it was due an inspection. So, i drove it down to get the inspection done. Passed the inspection and they backed the truck off the rack and i jumped in to see that the tach was on zero! I was like, what the crap...

So i turned the truck off and back on, no tach. It was working when i pulled in.

I did some searching and many seem to say it's a ground issue, so I just checked my grounds and they are all rock solid. Also note that a month or two ago when i did dual batteries i replaced almost all of the wiring from the alternator, starter and battery; add all new wiring with the wiring harness.

Any ideas? Did my tach just coincidentally die on the inspection rack?
 
No, in NC you have to have your vehicle inspected for safety. They just make sure you have working lights, turn signals, look to make sure you still have catalytic converters, ect... It's really just a visual inspection.
 
Do these tachs have a little plastic worm gears behind that drive the guage like others? They do wear out or brake over time...
 
well, it must of been electrical. Went out today and looked really hard at the igniter and my grounds. I looked so intently then when i started the truck this time, the tach worked. So.... no clue haha
 
With all that harness work id be focusing there if it returns. Congrats on getting that wrapped up; Hopefully it is GTG...... just dont let the smoke out if your back in there :)

Fwiw mine died momentarily on my pre purchase test drive in 04 and then again going to GSMTR in 09 and has otherwise been fine
 
Over the trip last weekend the truck performed great. No issues with the tach... until somewhere in the middle of little canada i glanced down and it died for about 5 seconds then came back on. Other than that, it was alive the entire trip.

Fingers crossed.
 
Over the trip last weekend the truck performed great. No issues with the tach... until somewhere in the middle of little canada i glanced down and it died for about 5 seconds then came back on. Other than that, it was alive the entire trip.

Fingers crossed.

Crossing one's fingers usually doesn't fix either electrical problems or plumbing leaks. :rolleyes:
 
If that is the problem, then you only need to replace the capacitors not the cluster or the ECU. Probably not too bad if you can solder.
 
Back
Top Bottom