Surface finish on head?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 8, 2005
Threads
82
Messages
1,575
Location
Grand Forks B.C.
What is the best surface finish to maintain a good head gasket seal, smooth or somewhat coarse?
It seems my number has come up and it's my turn to do a head gasket.
Is it common for most of the valve seals to be weeping?
Guides are mint but almost every valve seal is hard as rock and leaking.
 
That's the subject of a huge debate. Some think smooth allows the engine/head to move against the gasket for expansion/contraction. Some think a texture provides good grip of these same surfaces. I'm in the latter camp and feel if the gasket is moving relative to the metal surfaces - you don't have a proper seal.

DougM
 
After rebuilding thousands of engines, in a previous life, I can wholeheartedly say smooth surface.
 
And btw, I can remember when my uncle was first teaching me how to lock down, level and surface the head, that he would get completely unglued if I nicked the surface of the head after it was shaved. So totally smooth has been etched into my brain.
 
Last edited:
I know the Supra guys call for a mirror like finish on the head - but they are usually going for a minimum of 16PSI boost in their builds.
 
It depends on the block/head if both are the same textured works, with a steel block and alloy head, most recommend smooth. The block and head expand at different rates, so there has to be slip, if not the gasket gets torn up.
 
...
Is it common for most of the valve seals to be weeping?
Guides are mint but almost every valve seal is hard as rock and leaking.

Most 16yr old valve seals that I have seen are hard as a rock, replace.:D
 
If it were me and I had the head off I would do a valve job, or have a machine shop do a valve job. Not much to it at that point.
 
Back
Top Bottom