Super sensitive heater control

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

RPN

Joined
Jun 5, 2019
Threads
5
Messages
51
Location
New Zealand
Hello Folks, looking to dip a toe into the communities knowledge pool.

I have a 91 HDJ with the super HD-T. The issue I have is a unbelievably sensitive heater control - a movement of less than a mm - 1/32" of the sliding control on the fascia moves the cabin air temp from Antarctic/straight from the South Pole icy blast to instant greenhouse temps.... I spent the weekend trying to get it right, and failed.

Maybe my previous girlfriends were right, and I am an insensitive a$$hole, but I'm sure I remember getting other heaters set ok in the past.

Is this a common problem, is there a known issue and a fix, what do you folks think?

Gratuitous pic of the new bumper and tyre carrier below. Please note the frost on the grass, and appreciate the seasonal relevance of the problem.

20190630_123407.webp


Thanks for any and all assistance.
 
I've got a penpal in New Zealand who works on light planes. He cuts and stocks up a lot of wood for this frosty time of year.

So I assume that diesel 80 has a very similar arrangement to our NA spec gassers with a heat control valve in the middle top of the firewall. It might be someplace else on the HD-T though. I suspect something with how it hooks up to that valve or perhaps it's broken wire internally in the control cable. Have you been able to observe whether it travels the full distance to open from close as you move the lever in the cabin?

I guess I'd try to determine that first, which might tell you whether it's the valve or somehow it's getting superhot water from the motor.

Nice looking 80, BTW.
 
Thanks Greentruck. When the rain stops, I'll get out there and check.
 
Another possibility are failing solder joints within the dash control unit. There is one or more posts from a year to 18 months ago where a similar problem was corrected by re-soldering the connections on the slider control.
 
Good suggestion, Phil. I suspect something mechanical and that is possible. A failure of a stamped detend or pivot maybe? It's been years since I had mine apart, so a little in the fog on exactly what's behind the slider before it turns into the cable pull that controls the heat valve..

If abnormal temps can be quickly ruled out, as that would seem to present other sysmptoms more urgent than heat control issues, then it seems to be a matter of tracking the physical linkages on the Temp slider/heat valve path.
 
Thanks for the suggestion, you are correct that there is something odd going on, the slider movement isn't always transferred to movement at the valve. Sometimes yes, sometimes no. I'll have to pull the slider out and look at what happens behind there.
It can be done when I pull the dash out to fit the EGT and trans temp gauges going into the bracket we fabbed up this morning.
20190709_140652.jpg
 
Last edited:
Back
Top Bottom