Summer extreme top SOR

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 20, 2004
Threads
78
Messages
809
Location
Below Da Bridge
Does anyone have the summer top from Spectre? The one that looks like a half top? Is it well built, easy to use etc...

I did the search, but didn't see anything about it.
 
If that the one that is all mesh?

I bought the one that has the mesh insert that can be expsosed by rolling back the material.

With the mesh cover it flaps A LOT! Open, it is not bad at all. The mesh knocks the sun down quite a bit.
 
If you're referring to the half top that drops down to just above the rear heater, I have one. It's easy to use, it just slides into the channel on top of the windshield and over the B-pillar of the roll cage. After that, it's just tightening straps, but I have to re-adjust the hard plastic piece that goes in the channel on top of the windshield every week or so. It's a bitch when I forget and it works itself loose going down the highway. Is this what you're talking about??
robertfj453.webp
Babe the Blue OX 2.webp
 
Got one and it's well built, easy to use. You need a rollbar that is in the stock location though. Keeps you dry as long as your headed into the wind. ;)

Damn near impossible to see anything to the rear, but I think they made the back window bigger now. :mad:
 
Agree with Bigndn and CruiserNerd.

Definitely the trick is to get the distance between the top of the roll bar and the windshield correct, and I moved my rollbar back 2 inches recently (because my '40 is pre-rollbar era) to make it "right".

I have it on now, because it is good. :D
 
Oh yeah, I forgot to mention..........my problems with the half top were related to the PO being a bonehead and removing the spacers from the windshield knob bolt brackets..........therefore my windshield was allowed to pull back into the cab a bit. Just something to check if you're gonna get one.
 
bigndn said:
PO being a bonehead and removing the spacers from the windshield knob bolt brackets..........therefore my windshield was allowed to pull back into the cab a bit. Just something to check if you're gonna get one.

The spacers are tubing. And, you are right, they are important. I found that to make my hard doors and hard top fit the best, I took mine out. Of course, I have them to put back in if I need to or if I sell the thing. :)
 
IDave said:
The spacers are tubing. And, you are right, they are important. I found that to make my hard doors and hard top fit the best, I took mine out. Of course, I have them to put back in if I need to or if I sell the thing. :)


You are correct, somehow they were still behind the dashpad. Crazy, huh? Due to the tension required by the softtop, I would think that they're necessary, otherwise the windshield wouldn't allow the doors to fit.
 
Yeah, still stock configuration, so I should be OK. I knew I wanted more than a bikini because if it rains while driving, my neck gets wet-along with the inside of the windshield!

Thanks for the info!!

P.S. Yes, that's the one.
 
Oh, one other thing. I'm not sure if the PO trimmed the nylon straps that go to the footman loops or not, but if mine were a little longer, it would make my life easier with the location of the installed footman loops. So, I guess either pay careful attention to where you mount the footman loops or don't trim the straps until you are certain about the fit. Good luck!
 
Back
Top Bottom