Stupid question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 9, 2006
Threads
101
Messages
513
Location
Alpharetta GA
Well it is finally a slow day in GMC repairland(imagine that right?). My buddy started tearing down my rear diff and I remembered I never ordered a diff gasket. On removing my minis 3rd I just used a silicone rtv, is it the same for the cruiser or do I need a gasket?
 
Well the diff is out. There appears to be slight wear to the pinoin bearing and carrier bearings, not bad though. I just hope this fixes the noise!!:crybaby:
 
I've always used RTV, but I'm sure some will argue that the thickness of the gasket allows for proper spacing of the diff to allow proper alignment of the axle shafts. I don't think it's a big deal though.
 
Well it does appear it had a gasket from the factory. I called the Toy dealer across the st. and no one in town has one. He also said rtv would be fine, anyone else have some input on this one? I do appreciate your input Arya!
 
Please keep us updated as to whether this fixes your noise or not. I suspect my noise is coming from the rear diff too and will soon be pulling it for R&R. Also, if you find anything really out of whack that could be the culprit please post that too.

Thanks in advance!
 
Well we are finally done. Test drove it.......... IT STILL MAKES BOTH NOISES!!:mad: The gurrrrrr noise when letting off the accelerator when going down hill from 45mph and up and the repititive roaring noise at 75mph to 80. I also went ahead and changed front diff fluid, which looked horrible, t-case and engine oil. Oh well, the bearings did definetly show some wear and pitting and I at least eliminated that and changed the fluid.;p I have also changed the rear u-joints, and lubricated everything. I guess now it is time to tear apart the front end and maybe t-case. At this point I'm either going to sell it or keep driving it until it blows up so I can pinpoint where its coming from! Does anyone have any experience with the cruiser shop in Atl regarding fixing mechanical problems like this? Anyway, everyone have a safe St. Patty's day, I'm packed and the cooler is keeping the beer cold on the way to Savannah! :cheers:
 
Back
Top Bottom