STUPID Question - Side Marker Light

[Gauge]

I am at a total loss to figure this out. The side marker light burned out on my drivers side. This is the little light that goes on with the parking lights / headlights and wraps around the upper left corner of the front fender.

How do you replace the bulb? Do I have to pull the inner wheel well? Do I have to pull off the front headlight?

I can't figure this out!

 

[mabrodis]

Heheh...it's fun...

http://www.sleeoffroad.com/technical/tz_indicator.htm

Remove the circled screw, that's all...

 

[LX_TREME]

Pop the hood u'll see right exactly on top of the corner light like small philip screw, then pull 'em gently toward to you.. replace with HID bulbs ->bright & last forever..

 

[Gauge]

OK. I removed the small phillips screw on top. That loosened the top of the light, but there is another screw somewhere on the bottom that must be holding it because the bottom is still tight. Do I have to remove the headlight? I already removed the bottom blinker light, but I still can't see anything.

 

[Bear80]

just pull forward, you won't break anything and afterwards you'll see. reasuring hu ;p

 

[Gauge]

Got it! Thanks! Actually it wasn't that difficult at all. I didn't realize the bottom just slid out. Thanks again. You saved me a LOT of time!

 

[RavenTai]

That one stumped me and several others on this bord also.

 

[Trapper]

I remember going through this excercise a year and a half ago. I must have spent a half hour trying to find this "bottom screw" on the cruiser. Boy did I feel stupid when the thing ended up sliding right off.

 

[mjosoba]

. Thanks for this. I was about to start unboltong stuff. Maybe I should go start a new thread. Wind up the Nazis.