stuck antenna

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 19, 2006
Threads
108
Messages
582
Location
Plano, TX
I've read through a bunch of posts and found a bunch on replacing the mast. How about getting the mast back in? Mine is stuck up (HAHA I never thought that would be a statement I'd be asking for help with...at least not from you guys :flipoff2:) The motor seems like it's running fine, just doesn't move the mast.

Thanks
 
Take that little retainer ring off at the base. There is a special tool that slips over the mast, but if you tape the area around your base, you can use needle nose pliers to get it off. Turn on the radio and extend the antenna and it will spool it out...the metal mast and a long white nylon/plastic tail with gear teeth on it. Insert the new one and turn off the radio and it should suck the new one back in. Reinstall the retainer ring and you are done. Unless your old one left a chunk of the old mast inside, in which case you might need to remove the motor to get it out, and that's a PITA.
 
Here is the process I followed:

Power Antenna Mast Replacement

Once the cable breaks then the antenna won't go up or down, doesn't matter. I guess it just depends on which position the antenna was in when the cable broke which appears to be the issue since you stated you can hear the motor running.

I think the problem for you though is, IIRC, the older FJ80 and FZJ80s are different from the later models in that the cable is actually attached to the motor/wheel which means you either replace the entire assembly or get creative with attaching the new mast. Definitely not as easy as the 15 minutes it takes to replace the mast on a later model IF you can get the old cable out without having to remove the motor.

Replacing the motor also means running a new antenna lead into the rig (IIRC) which means even more of a PITA.

Good luck with it.
 
Back
Top Bottom