Strange sounds

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 5, 2008
Threads
20
Messages
47
Location
Bozeman, MT
Hello,
I installed the OME bushings and did the axle service approx. the same time. After the job was done, the car started experiencing sharp squeaking sounds coming from the DS front tire and the middle left of the body. In addition, when I brake and turn left the brake/knuckle area will make a 'popping' sound. During the axle service one of the pistons came out and I had to reinstall it in the caliper. Any ideas as far as what to check for the culprits of the sounds? I am coming to the point where I may just redo the axle service on the DS again. Thanks for the help.
 
Tighten the bolts that hold the control arms on. Had the same thing happen on mine.
 
130ftlbs for the arm to frame bolts (2 of them, tighten the nut), 127ftlbs for the arm to axle (4 of them, tighten the bolt).
 
Sweet thank you! i just put Slee blues in, snugged them up good, but have been meaning to revisit and be sure they are really set. Much appreciated.
 
Anyone have an idea as to the popping sound? I was thinking that the bearing was not properly seated but I tightened up the lock washer and am not sure if the piston is somehow unseating/moving. Thanks for the tip re the CA's, I will tighten those up.
 
Thanks for all the help trying to pinpoint this sound. I torqued all of the bushing bolts to spec (except OME stabiliser which I just tried to torque until very very tight). The sound def. seems to be coming from the front/middle of the car, almost where the control arm connects to the frame. I remember the machine shop I took the CA's to accidentally pressed out the rear bushing, then repressed it (so he said). I checked the torque back there, any more ideas? Thanks.
 
Back
Top Bottom