strange CDL problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

BGMachine

Working on cars I can't afford
Joined
Jan 19, 2014
Threads
53
Messages
359
Location
SE Michigan
Hey all, So I'm planning on going on a wheeling trip this weekend so I went to an abandoned mall parking lot today (its very gravely and rainy today) to make sure all of the locks are working. I have a CDL switch on the dash so I would push that, hear the relays click, then nothing. No light or other indication that the CDL was engaged. I did some tight turns to see what was up and the rig hopped and bucked and the tires skid like it was engaged. Only there was a loud popping/clanking sound coming from the front as the truck lurched. I would then click the switch to disengage the CDL and hear the relays click again. If I went forward in a turn, the rig still lurched and hopped. If I did a turn in reverse, the CDL would open back up then it would drive like normal from then on out. Does anybody know what could be happening? I feel like the CDL is partially engaging but i'm not sure. I had put a heavier weight gear oil in the Tcase a month or two ago would that be effecting it? Thanks for the speedy help.
 
Did you install the CDL switch or was it there when you bought the truck? Have you confirmed the PIN-7 mod? Did you try to engage it in both hi and low range? Have you tried to pull the sensor from the top of the transfer case and clean it?
 
I installed the switch and I haven't done a pin 7 mod. I did try in both hi and lo gear. I have the sensor out now and I'm cycling it a bunch. I need to wait for a fried to get back so I can see if the sensor turns on the dash light when I push it with my thumb
 
Ok so I got it all sorted. While I had the sensor out I engaged and disengaged the CDL a bunch until it started making the satisfying click of full engagement. I guess it's just because I haven't used it in a while. Nothing like a little pre trip panic. :doh:
 
Glad you got it sorted out.
Until you do the PIN 7 mod the CDL will only engage in low range.
 
Last edited:
Glad you got it sorted out.
Until you do the PIN 7 mod the CDL will only engage in low range.
Are you sure about it only engaging in low?
 
Are you sure about it only engaging in low?
Doug, yes, I am wrong :D. CDL switch without the PIN-7 mod gives you the ability to engage the center diff while in hi range but will still auto lock while in low. The PIN-7 mod gives you the ability to make it selectable while in low range. It had been a while since I had read up on it and got my wires crossed. :confused:
 
Back
Top Bottom