still got clutch problems

[void]

G'day

i had a new clutch put in and they guy said the clutch master cylinder is shagged and i need a new one. sooooo i have bought a new master and slave cylinder and installed them both. bled the lines with the old 2 person trick but still have to pump the clutch to get some pressure build up.

i will re-bleed the lines but incase that doesnt work has anyone got a solution for my problem?

cheers
Aidan

 

[vk7ybi]

Proper adjustment of pushrod to clutch fork?
Did you bench bleed the master before installation?
Gravity bleeding works on the brakes for me, so should work on the clutch too..

 

[cruiserbrett]

is the bleeder screw above the hose fitting? some older v-8 conversions I have seen had them mounted upside down, and were impossible to bleed without removing the slave from the brackets?

 

[void]

i adjusted the push rods a bit and it all seems fine at them moment. dont need to pump it any more. hopefully its all good for a while.

thanks for the quick replies

Aidan