Steering Staberlizer

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 2, 2008
Threads
74
Messages
156
Location
Charlotte, NC
I am getting ready to put some new BFG's on my rig and was wondering if I should replace the factory steeting staberlizer before I have it realigned? If so, what so i go with? I am going with the All Terrain 285/75/16's
 
Are you lifting the truck at all, or is it lifted already?

You can wait to add the stabilizer later if you are going to lift which will require you to get another alignment anyway, unless it's time to change it then you don't have a choice. I swapped mine thinking I needed it and I didn't. My truck had 100K at the time. It won't hurt if you want to replace it, I'm just saying if it ain't broke don't fix it put that money somewhere else. I've learned lot's tricks here from other members like the fasmous WHILE YOU ARE IN THERE QUOTE" But If you need to get one, you can always call SLEE offroad or MAN A FRE for an OME. I think I paid about 80 dollars shipped, oh and be ready to use a BFH and some HEAT! cause it's on there.

My 2 cents.

-Juan
 
My 2 cents is that if you have ran 33"-plus tires for anything over 5 minutes, your stock steering stabilizer is probably shot. Big tires just sit around laughing at factory stabilizers. My guess is that Slee and MAF sell a heavier duty stabilizer similar to ours.
 
If you want to replace it, use the proper tools.

Namely, a pickle fork. (I think Harbor Freight lists theirs as a "steering stabilizer and tie rod end removal tool".)

This is one of the (relatively) few parts that going aftermarket on makes sense, even for a stock height truck. The OME stabilizer is around $75-80, and is a *LOT* easier to put on and take off than the OEM.

All that being said unless you have a lift or big tires it's probably not needed. Plenty of rigs 200k+ miles with a stock steering stabilizer, and no problems.
 
Back
Top Bottom