Steering shaft DOH!!!!

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

green73 said:
Oh sorry it's an FJ40 with FJ60 PS conversion. There are pix in a back issue of "Toyota Trails". I am sure I simply didn't torque the bolt down after aligning the steering wheel. It separated at the firewall connection. The simple suggestions are always the best. It never dawned on me to tack it in place.

The clamp bolt should sit in a groove in the column shaft to prevent this happening.

It shouldn't be possible for it to fall off with the bolt still there...
 
I had nothing to do with the TT article, other than my rig being modded while the article was written.

As for the groove on the column shaft, I know it is there and I overlooked it when I was aligning the wheel. I am thinking I slid the yoke too far up, then tightened the bolt. Over a period of time and 2 wheeling trips, it slowly slid down and eventually off. I just got lucky that I wasn't moving when it did.
 
Back
Top Bottom