steering box rebuild

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Overhauling is simple. Remove the steering column, remove the pitman arm (you'll need a pitman arm puller), then unbolt it and pull it off. A great resource is http://www.globalsoftware-inc.com/coolerman/fj40/21A.htm You don't need to dissassemble the steering column or anything else, even though it describes how. Just do the steering box section. Good advice, and plenty of humor thrown in to boot!

You'll need 098-49A seal, 098-09B gasket, and 098-01 seal from Specter Off Road. I'm in the process of overhauling mine, so I'm in the same boat you are. Unbolting and removing everything is easy, just remember how it goes back in!! Once you get it back on, rotate the input shaft all the way one way, make a reference mark, then count the revolutions all the way to the other, divide by 2, then rotate it to exactly half, then stick the steering column on, and then stick the pitman arm on dead center up and down, bolt on. Good luck!!
 
Hi All:

To stop or at least slow the leak from the steering box just re-fill with knuckle grease instead of 90 weight gear oil.

"Landcrusher909," if you are interested I have an extra manual steering box you are welcome to for the cost of shipping. Then you can re-build the steering box while keeping your rig on the road!

Let me know if interested.

Alan
 
Back
Top Bottom