Steering and axles

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 8, 2003
Threads
372
Messages
6,845
Location
Bozeman, MT
Howdy-

I just read up on the DEATH WOBBLE, some good advice, it answered a lot of my questions. But I do have a couple more. Truck is a 76 fj40, 33's and 4" lift.

My steering stabilizer gave up and shot oil out all over. This is screaming that there is a bigger problem than what I thought... or at least it isnt just the stabilizer.

I have all the death wobble indicators, happens after a bump around 35-40 miles an hour.

I know I should check the: wheel bearings, knuckle preload, all bushings and TRE's, I am swapping over to minitruck soon, anywhere else that I should be looking this weekend?

Also, I need a new stabilizer, any suggestions I wont be using the same kind that just blew out... black diamond.

Thanks in advance.

Rezarf <><
 
TREs are very suspect but your caster angle may be all jacked up and that has severe effects as well.

I don't run a stabilizer - no wobble, that is just a band aid - there shouldn't be much use for one if everything else is tight.

Do you have power steering?
 
New TRE and I have the shims (4 degrees I think) installed correctly...

Where the heck can you find a hub socket for the 54mm wheel bearing nuts?

Thanks in adavnce.

Drew
 
Drew, when you get that large in any size, you can always find an SAE that will fit. I think on my '66 we used a 2 1/4", IIRC.
GL
Ed

Also check your center arm and adjust it if there is play in it. That is if you still have a center arm.
 
Degnol said:
Drew, when you get that large in any size, you can always find an SAE that will fit. I think on my '66 we used a 2 1/4", IIRC.
GL
Ed

Also check your center arm and adjust it if there is play in it. That is if you still have a center arm.

It's a 76 Land Cruiser so that means it's disc brakes not drum. You need a 2 1/8" socket and you can find that at Sears for about $20 or so. You might be able to find it some place cheaper but that is the correct socket size.

Make sure to check your trunion bears as well because that could lead to a death wobble.

I also don't run a steering stabilzer so that should not be the problem.

Travis
 
Gotta a used Heckethorn big yellow steering stabilizer, how about 15 bucks and the ride? Comes with the mounting brackets if you need them.

Send me a PM with your email for a pic.
 
Back
Top Bottom