Starter Issue

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 31, 2015
Threads
60
Messages
1,451
Location
Stallings NC
I just recently developed an issue with the starter. Sometimes when I attempt to start, it sounds like its grinding. It doesn't happen every time, and will always start eventually. I replaced the starter and plunger a few months ago but just developed the issue recently. Any ideas?
 
You mentioned you replaced the starter and plunger a few months ago. Are you sure you replaced the starter and not the contacts? The plunger and contacts are fine (in the solenoid). The starter gear itself is not fully engaging into the flywheel causing damage to the gear or the flywheel. Replace starter.
 
You mentioned you replaced the starter and plunger a few months ago. Are you sure you replaced the starter and not the contacts? The plunger and contacts are fine (in the solenoid). The starter gear itself is not fully engaging into the flywheel causing damage to the gear or the flywheel. Replace starter.


I replaced the contacts and plunger, not the entire starter. Is there a correct way to reinstall the starter after removing it? I cant figure out how I could have reinstalled incorrectly.
 
installing the starter is straight forward, 2 bolts through the bell housing, plug in the signal wire, attach the power to the b+ terminal and away you go. im sure that the reinatall is correct but maybe there was an issue on reassembly when you rebuilt it.
 
Back
Top Bottom