Start of Homemade 52mm Gauge Pod

[kevinmrowland]

Location

United States

I found these exhaust tips at the local auto parts store (for $8 a piece). 52mm (2 1/16") gauges fit perfectly inside the non flared end.
I cut these two to an even length and cleaned the cut in preparation for making gauge holders.
I got distracted, ended up going a different route, can no longer return them since they are cut and feel bad about wasting the money.

If anyone is interested, $12 for both. If you want I will sand blast them in prep for some nice flat black paint.

 

[RHINO]

so how did you end up going with the gauges? and change yer sig slacker!!!

 

[kevinmrowland]

https://forum.ih8mud.com/showthread.php?t=159678&page=4&highlight=1HZ+swap
Post#117, have two sitting on the dash, oil, boost, pyro, altimeter, inclinometer.
I think my sig is still accurate enough No need to brag.
And sorry we never made it over/up to the hot part of AZ, we will be back.
Enough chit chat, back to selling stuff.