SR and shackle length

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 3, 2003
Threads
57
Messages
247
I am a bit confused. I have heard and read that with a SR you will gain about 2". If you have a SR in the front and the rear original aren't you only gaining in the front so thereby you must extend the rear shackle 2" longer than the front to match. And what if you are hanging the rear shackles off the frame and not hangers?
 
Eternal said:
I am a bit confused.


So am I.



Eternal said:
And what if you are hanging the rear shackles off the frame and not hangers?



Are you talking about the shackle hanger on the front axle or the rear?


I would do the swap, and then fabricate shackles that make the vehicle sit how you want it to, and that will work well with your intended use.



Good luck!


-Steve
 
Eternal said:
I am a bit confused.

Phrased that way - so am I :D

I'm doing a shackle reversal with my SOA project where the front hanger is right on the frame (same as those who relocate the stock rear hanger to the front), the rear shackle hanger is below the frame, and I decided on using 2.5" over stock anti-inversion shackles to match the 2.5" over stock confers I already have in the rear. Hypothetically - I'm thinking it'll sit nearly level.

Regarding the front shackle reversal - the only worries I have are how much more slip I'll need in the d-shaft due to the shackle hanger being below the frame rail versus drilled thru it. Hoping not to have any major problems as I'm using a cut and turned axle and I've got a 8" or so High Angle driveshaft that I can relengthen if absolutely need be....

As long as the pinion angle is set right - where the rear shackle hanger really makes no difference right ???
 
Back
Top Bottom