Square tube bumper

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 16, 2002
Threads
56
Messages
435
Location
Northeast PA
I am building a square tube bumper with swingout tire carrier and hi-lift jack holder. I was wondering how you guys mount bumpers like this. I was thinking about taking off the original bumper and welding brackets on to go inside of the frame rails.
 
Ya mean like this?

http://www.ironpigoffroad.com/40bumpers.htm

Just had a loooong discussion with Lance about this yesterday and will be ordering one of his when the new design comes out in a month or so. His design uses the 4 main hitch holes in the center and the two outside bumperette holes on each side (these you drill out to either 5/8 or 1/2) bolting to the rear x-member.
 
I was actually thinking about pulling off the old bumper and making some kinda bracket. Has anyone done this? Kinda looking for some pictures if anyone has any. It looks like in the attachment it is just bolted to the original bumper, correct me if I am wrong but I want to get rid of that and come up with something new...
 
Thanks Scott.

This is just how I mounted it to the rear crossmember. Of course it's rectangle tube rather than square. If you read my build up thread (link in my signature line) you'll see some views on whether or not to replace the rear crossmember while you're at it. Personally I would consider that a whole different undertaking rather than doing it just to have a new rear bumper. Just me, but that's a good bit of additional work.

attachment.php


Good luck and hope to see your product.

Jeremy
 
The rear crossmember is just that, replacing it is a little comlex as the rear spring mounts and body mounts are also attached to it; hence the reason for bolting on a rear tire carrier. I replaced my rear cross-member, but I also had to fab some custom rear spring mounts and body mounts to do so.
 
Last edited:
Back
Top Bottom