Spring Wedge

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 12, 2006
Threads
73
Messages
517
Location
Richmond, VA
OK...the PO put an OME 5" comp lift on my 80....Can;t say I'd have done the same, but hey, it works even if it rides like a brick.

In the rear, with the adjustable uppers, the rear spring need a spring wedge in there to keep them flat on the lower perch. I want to make a spring retainer for them anyway to keep em from flopping out at full droop, but has anyone ever made anything like that.

I know on my rover, we used a wedge, but havn;t seen one for the 80 yet...any ideas?
 
Generally speaking the springs coming loose during full droop is not as issue as with Rovers. I have seen the cones or wedges you mention and at one time I considered fabricating a pair but I have yet to actually need them. Unless you have an exotic setup with super long travel shocks with the comp springs it is unlikely you'll need them or the retainer clips.

Now your idea about the retaining clips if used on the upper and lower portions of the spring would be a benefit because the suspension wouldn't completely unload as the Rover rears and occasional Cruisers do. The lower portion of the springs would be easy, it's the uppers that pose more of a challenge due to space constraints. If upper clips are feasible limiting straps would perform the same function.
 
Yeah, not the cones. Tried that for a wheeling trip and quickly removed them and retained the spring. I am just concerned aboutthe bottom. The top will always have the bump stop to make sure the spring stays put, but I make a retainer out of some bent flat bard and weld a nut inthe coil bucket seat to bolt ot down.

I had even considered cutting off the mount and replacing it with one the ballistic fab coil/retainer perches like....
Coil plate mounts with retainers
 
Back
Top Bottom