spindle wear

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 24, 2007
Threads
4
Messages
13
I've started to repack my birfields and unfortunately the morons who did this job the last time didn't put enough grease in the driver’s side. I think the majority of the grease that was in there was what I pumped in during my 3 months of ownership. The bushing has some scoring. The FSM only says to inspect for damage. I'm wondering if I should replace the bushing. My first instinct is that it isn't that bad but I'm curious of others opinions. What are the symptoms of a bad spindle bushing? The only issues I had and the main reason I repacked it so soon was a light clicking when turning uphill.

Thanks

Tobin
IMG_0904s.jpg


IMG_0919s.jpg
 
The clicking you has was probably the birf itself. Did you take the balls/cage/star apart to inspect?

You can usually swap the birfs to opposite sides to get a little more wear out of them.

I had some spindle wear, but not as much as yours. I decided to put them back on and as long as they hold up I will buy a set of the new spindles that have needle bearings instead of bushings.

IIRC the brass bushings aren't cheap but definitely cheaper than new spindles.
 
Run it.


No, really, run it.


There is A LOT of life left in that bushing.

Grease it well when you put everything back together and you will be fine.


:beer:
 
That's what I thought. I had a mechanic friend of mine look at it and he said he thought it would be ok. He did say it might not be a bad idea to switch sides so it is on the short side. When I searched I read some past posts that claim the drivers side tends to wear faster because it is the long side. It just really irritates me that some body could put it back together with such a small amount of grease.

Thanks

Tobin
 
Back
Top Bottom