Spindle Bushing removal

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 9, 2018
Threads
11
Messages
129
Location
Oakland California
Someone posted a thread showing how they beat and cut this bushing into submission and another guy used a 3 jaw puller from Harbor Freight, more my speed. I know I didn't have to swap this thing out but it came with the box of knuckle stuff so what was I going to do with a random bushing if I didn't install it? I don't know either. Maybe this will help someone who is faced with this task and they really do have to swap it out. Takes less than a minute.

puller2-X2.jpg


The one modification needed is to grind the edges of the jaw lips flat.
grind-X2.jpg


Here is a short video of the work. It took a minute to set the jaws inside then I rested the spindle in a vice, not tight, just enough to keep it from falling over while I was cranking with one hand and filming with the other.




https://photos.smugmug.com/Land-Cruiser/i-DHLWtSs/0/9a735df2/1280/IMG_3005-1280.mp4
 
Back
Top Bottom