Speedometer

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 10, 2006
Threads
99
Messages
501
Location
The Ghetto
I took my dash off when I was doing a complete rewire and I disconnected my speedo cable from the speedo and now it doesn't want to connect back. WTF? How would I know if the cable is broken?
 
Awesome. Makes sense. How would I disconnect the other end from my NP205? Now what if it doesn't reconnect? I couldn't find a speedo cable for a 205 anywhere. How mucha re we looking at for cost for a replacement?
 
Righty-tighty, lefty-loosey....

Back the nut off that retains the cable onto the drive on the tcase.



Are you running a stock Land Cruiser insturment cluster, or aftermarket speedometer and gauges?


Nevada Speedometer has taken care of me in the past, and depending on where you live, look in the yellow pages under insturments and you may just find someone in your back yard....
 
My guess is that the square drive of the cable is not matching up with the female portion in the speedometer. I had a similar problem with mine. It just took a lot of fiddling around to get it back together. Have patience, you'll get it. I moved my truck back a bit and got the cable and speedo to match up again.
 
Actually the speedo is still hooked up but the sheath nor the retainer screw will go back on. The sheath retainer screw stops short of following the threads to where the cable goes into the speedo. I have posted that before that the odometer stopped at 340 miles and hasn't moved since I bought it as well but I could tell how fast I was going then before I disconnected it. I remember someone saying it might be the numbers that froze up inside but i'm not sure.

Also, the whole cable and sheath have somewhat of a tight fit as far as length from the t-case so i'm thinking that the cable broke off somewhere from the speedo to the t-case inside the sheath. I tried pulling the cable a little more out from the firewall to see if it was length but it seems like something different is holding it back. Another thing I thought was some frame retainer brackets keeping the cable from getting slack from underneath but I am going to have research this some more. I'm getting new gauges anyway so getting a new speedo wouldn't hurt anyway. Plus, the cable hook-up to the t-case is leaking anyway so shoot maybe I need a whole new cable. Shoot...maybe I need a new cruiser. Don't we all?

:rolleyes:
 
mdjohnsen said:
Plus, the cable hook-up to the t-case is leaking anyway so shoot maybe I need a whole new cable.




Or just the felt or rubber washer designed to seal the cable to the drive.....
 
I had the same problem reattaching my cable under the dash. I ended up disconnecting the other end to give me more play and the it was no problem. The trans end is easy to connect.
 
Back
Top Bottom