Speedo not working....

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 16, 2005
Threads
88
Messages
797
Location
Virginia
Hi all,
I have just installed a new speedo cable and tried two different but functioning speedometers and neither one works when I connect the cable to the tranny. I can spin the cable from under the truck and the needle moves...but when I attach it to the tranny and drive....I get nuthin'.

What would cause that cable/tranny interface not to spin/work?
 
Plastic gear that goes into the transfer case is stripped. Easy removal/replacement from outside the transfer, 10 minutes tops. Order the speedo drive gear, go to that end of the cable under the truck, pull the hold down bolt, remove the housing, replace gear, one banana tops.
 
Oh very timely info, just swapped a different trans and transfer and now my speedo quit working, thanks Texx, I will just take my old one out and swap it.
Love this forum.
 
I pulled the speedo gear this weekend, it says 6X17 on the shaft. So, I figured I'd order one up from SOR by just giving them that spec. However, the gear didn't look all chewed up at all. The splines were warped a bit, with the middle section a tad bit lower than the ends, but otherwise it appeared to be in decent condition. So....

My question is, could it be that the PO installed the wrong size in the first place and that I'll need to order the next size up?
 
I replaced mine this weekend with the old one from the original trans, the bad one was shallow in the middle just as you discribed. Not by a bunch.
 
Back
Top Bottom