something wrong

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 3, 2007
Threads
21
Messages
50
Location
Awendaw,SC
Alright I went out mudding one time and got stuck. when I got pulled out and tried to drive away my truck cut out. well It starts about 5 min. later and every thing was fine. well I went down a trail a few weeks later and there is a mud hole right befor the trail. when I went through it I made it almost all the way through until my truck started to cut out. then when it was right about to die it fired right back up. It also happened when I went back through the hole. What is going wrong here. the hole was probably up to the bottom of the front bumper(stock susp. 33" tires).
 
This is why the forum is called ih8mud :doh:

But seriously, maybe something wrong with the o2 sensors. They get wet and short out. When the exhaust warms things up, they are once again operational. But on the other hand the engine would go into open loop, retard the timing and not die...
Hmm.... maybe someone else will chime in because I actually don't see anything on that height that would be adversely affected by water. We've got the oil pan, tranny pan, transfre case, AC thingy behind the bumper, wheels and exhaust.
 
Water in the dizzy from the cooling fan?
 
Nope, water splashing up on the distributor, O2 sensors are always wet due to their localtion.
 
Alright I went out mudding one time and got stuck. when I got pulled out and tried to drive away my truck cut out. well It starts about 5 min. later and every thing was fine. well I went down a trail a few weeks later and there is a mud hole right befor the trail. when I went through it I made it almost all the way through until my truck started to cut out. then when it was right about to die it fired right back up. It also happened when I went back through the hole. What is going wrong here. the hole was probably up to the bottom of the front bumper(stock susp. 33" tires).

My first thought is also water on the ignition wires, distributor cap,etc. Each wire is silicone sealed to it's connector when new, but this breaks down with time, allowing water to get in, but also for sparks to get out if you get too close with the engine running(ouch!)

New ignition wires that are firmly connected may help, but first
I would avoid mud puddles.

g
 
Back
Top Bottom