Soft Brakes

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 19, 2007
Threads
14
Messages
36
I need HELP! I replaced the right front brake line, bled the brakes, replaced the brake fluid, changed the master cylinder, bled the brakes again, adjusted the pedal height...they still feel soft and spongy, they won't lock up when I floor the pedal. I do not hear the wear indicator for the pads but could it be the that I have worn brakes? What els could be wrong?
 
Did you bleed your LSPV?
How much fluid did you go through?
I did mine and sucked air while i was doing the rear (didn't realize the resivour had a divider in it) it took more fliud than I would have thought to get the air all the way to the back.
 
I actually replaced the master cylinder...I bench bled the MC and ran two large continers of 3DOT fluid through the system. I also bled the LSPV. Any other suggestions? Its just really disappointing that after all the work I have done the brakes feel exactly the same ...am I missing something ? What is an FSM?
 
Factory Service Manual

Actually if I remember correctly the FSM has you bleeding the brakes in the reverse order (that is backwards from the way I have been doing it for 25yrs, farthest first/rear right to closest last/left front)

maybe try bleeding them in the other direction?

the other thing I gave up on was the "one man" vacuum bleeder, I whent back to doing it the old fasioned way with two people.
 
A thought came to me this morning:idea:

If you have not changed your pads you may have air trapped behind your brake pistons.
When I replaced my pads there was a pretty large difference in wear over all 8 pads, the thickest was only half gone and the thinest was @ zero (inside front right)
Your front calipers with worn pads will hold an entire resivour full of fluid, this may be were your problem is.

Replace all your pads, its dead easy and a cheap piece of mind.
 
Back
Top Bottom